What is mean by PID controller? And what is its Long form?
- 9 Answers
- 27678 Views
- Jindal, I also Faced
- E-Mail Answers
Answer Posted / prerit
Pid means PROPORTIONAL INTEGRAL DERIVATIVE controller
| Is This Answer Correct ? | 85 Yes | 9 No |
Post New Answer View All Answers
What is meant by reset level of the relay?
WHAT HAPPENED DC SERIES MOTOR FIELD WINDING OPEN. CAN POSSIBLE.
how to determine ct ratio in ht vcb?
How one can check the MAIN of a house wiring ?
How REF protects transformer alone? explain with diagram.
Dear sir, my knowledge about cable size determination is limited. Though I read examples I could not calculate the Cable size required for electric driven pump 40 KW, 380 Volt, 50 HZ, 50 meter from transformer and it is three phase star delta starting. Please help as there is no one in my surroundings to help.
how we calculate electrical load on a building according to area?
How wire size can define in electrical wiring? What is the ratio?
A 7 storey building has a floor area of 35,000sq.ft on each storey. On the ground floor 11KV electrical sub-station is to be erected. A load of 3kw for every 400sq.ft (p.f is 0.8) is proposed for each floor. fire pump 7.5hp, water pump 5hp, lift 2 nos, each 10hp and 20shop load of each shop is 5kw. calculate a. load each floor b. total load of building c. L.T feeders for aech floor and from transformer to main. d. distribution diagram e. capacity of sub-station/capacitor bank f. line diagram
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
Percentage losses in power generation?
If VFD is On but no starting commond on it. so how many outpout voltages of VFD
why the neutral point in connnection oscillates?
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
What is 100% protection of generator? Why 100% is not used but 95% is generally used?
