Answer Posted / m.varadarajan

when higher hp motor starts with high current, to reduce
the starting current we are using this connection,it will
reduce 1/root3 times of full load current, after motor
reaches of the rated speed, delta connection applied.this
time full voltage applied to winding and motor run smoothly.

How many types of colling system it trformers?

1140

---

What is the difference between Generator Differential Relay and Transformer Differential Relay?

2227

---

what happen if the load connected to the induction motor is taken away? the same question for synchoronous generator in synch i think that the the exitation voltage will appear on the terminal only if so plz answer me

1961

---

can i connect wavetrap in 2 different phase in EHV line?

1803

---

Convert a star connected network into a delta connected network.

1082

---

what are problems caused by the pdu in rack server

1938

---

how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING) I O (current operating)?

2179

---

When calculating the speed of a rotor required for a particular frequency of synchronous generator we use the equation 60f/p Is this p is the number of pole pairs of rotor & do we consider the number of pole pairs in the stator is 1?

1956

---

how ups works ? various parts of ups and working principle

1930

---

What is the ratio of true power to apparent power in an ac circuit?

1105

---

how is the incoming cable size calculated for a given current rating of a panel??

1895

---

What is difference between Over Current & Earth Fault protection?

2401

---

what is the use of power transformer in GSS.

2450

---

Logic using 1 kV or 1,1 kV grade in house wiring Low voltage cable. Explain/suggest? some use 1kV and some prefer 1.1kV grade insulation low voltage cable why??

1610

---

What is the disadvantage in proportional controller?

1109

---