What is auto transformer?
Answer Posted / shiny ayub
An autotransformer is an electrical transformer with only
one winding. The winding has at least three electrical
connection points called taps. The voltage source and the
load are each connected to two taps. One tap at the end of
the winding is a common connection to both circuits (source
and load). Each tap corresponds to a different source or
load voltage. In an autotransformer a portion of the same
winding acts as part of both the primary and secondary
winding.
| Is This Answer Correct ? | 27 Yes | 2 No |
Post New Answer View All Answers
What are the transformer losses?
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
what happen ehen synchronisation is done at below rated speed
give single line diagram of D.G distribution form alternator to main L.T panel?
which type of questions asking for solar companies?
What is the use of Surge Capacitor in LAVT?
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
Salient pole alternator is more stable, why?
gas turbine genrator reactances
please tell me, how i clear the objective test? when i studied form the one book after i solved the objective ,that time i solved that qes. but if i tried solve objective form the other book then i could not solved these que.
What is dc current source?
how could we calculate the no of outgoings from a 800 watt distribution board
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases flux A does not alter B decreases C increases D none of above
what are the maximum available current, voltage ratings and switching speeds of the power electronic devices thyristor, power mosfet, igbt, and mct?
What is the function of the circuit breaker failure relay?