Questions :-
HR-
Q.1 about yourself & family background ?
Q.2 Why u choose Power sector as ur carrier starting not any
other sector ??
Q. 3 What think abt NTPC ?
Techincal Questions:-
Q.1 about Vocational Training……What u did , see the main
equipments….etc
Q.2 Why a transformer Noise during its running condition ?
Q.3 about transformer oil material & Test name for the
measurement of its dielectric strength & wht will u do if
its dielectric strength goes low ? ……..some discussion type ?
Q.4 What is relation between transmission lines &
Communication lines ?
Q.5 Which Machine u will prefer to use at a place where
flammable gases are coming out & why ?
Q.6 how fault in an electric system is detected & hw
protection of equipments is done ?
Q.7 Why we didn’t feel electric shock in an electric train ??
Q.8 Anything u want to ask from us ??
Answer Posted / kumar
please send the answer to kumar4486@yahoo.co.in
| Is This Answer Correct ? | 4 Yes | 4 No |
Post New Answer View All Answers
testing of Vector Group – YNaoD II
how to calculate the earth fault current
What is the unit of magnetic flux density?
Difference between Earthing Truck & Earthing trolly for HT panel
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
Do inductive loads have distorted current waveforms ?
In how we connect watt meter for open & short circuit test of a single phase transformer.
what is the necessary of using inductance property in transmission lines even through resistance is used to opposes the high current flows in that?????
what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem
How a band pass filter is constructed?
how we decide wire gauge for ac or dc coil and what is the basic diff. B/w these two coil?
If symmetrical fault occurs at the terminal of a synchronous motor then how the motor will act...explain it..
what are the parameters plays a major role in Potential transformer Burden calculation??
What do you mean by turns ratio of instrument transformer?
What is the instrument to check the rotating diode fuse of alternator in running conditions?