Answer Posted / ajaz ahmad wani
In computer networking, flow control is the process of
managing the rate of data transmission between two nodes to
prevent a fast sender from over running a slow receiver.
This should be distinguished from congestion control, which
is used for controlling the flow of data when congestion
has actually occurred
Posted By
Ajaz Ahmad Wani
Network Engineer
E-mail-baba.ajaz@gmail.com
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
Tell us the name of best path in eigrp protocol?
I simulate ten routers r1 to r10 straightly. I want I can ping from the loop of r1 to loop of r10, but I want I cant ping r1 and r10 from inside routers.?
Explain the difference between baseband and broadband transmission in ccna?
How many valid ip will b in /21 in route summarization?
What is refresher?
Define the igp (interior gateway protocol)?
Which command we give for live view of remote site routers?
What is syntax of ipv4?
What are the different types of the password used in securing a cisco router?
What is ospf? Describe it.
Mention what is dhcp?
Hi Jitendera, Wat do u do..?? I mean r u working anywhere???? Basically where r u from??? If u don't hv any problem, u can say..?? Or else mail me mr.shahin07@gmail.com
What are the conversion steps of data encapsulation?
On which mode we give debug command?
What is Phase od VPN in site to site and what information you will require to configure a SITE to SITE VPN
