Interested to Buy Any Domain ? << Click Here >> for more details...
whatare the load combinations which are used for the
foundation design in a tall structure ( 10 storied
building)?
- 5 Answers
- 11973 Views
- I also Faced
- E-Mail Answers
Answer Posted / ashish
DEAD LOAD
LIVE LOAD
IMPOSED/IMPACT LOAD
WIND LOAD
SEISMIC LOAD
| Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
What is passive earth pressure ?
water leak detection system question & answer
How should we design a brick column and footing?(note: no reiforcement to be provided) Can you tell me any reference book where i could possibly find this design? Plz help urgently
What is high adherence steel bar? I have a general specification which refers to High Adherence steel bars, coils and meshes to BS EN 10080 and BS 4449 or BS 4483. Is this just general re-bar or is there something different about it? The spec originated in France.
What are the techniques to measure road difference?
1) write Short notes about Shellow & Deep well? 2) What is the full form of SPT & SMB? write short notes. 3) write short notes about efficiency of Riveted joint.
100mm block work 64 bags of cement used 150mm block work 286 bags of cement used 200mm block work 20 bags of cement used patly work (M15) 293 bags of cement used mortar ratio is 1:5 how to calculate volume of sand in cum & no. of bags
5. Two long boundary walls run parallel to each other at a center to center distance of 1 meter apart. The width and height of the first wall are 0.30 m and 2.5m respectively. While those of the second are respectively 0.18m and 3.5m. Plot the distribution of vertical stress intensity due to walls on a horizontal plane, 1m below ground level. The walls have negligible depth of foundation and are made of brick masonry (y = 19.2 kN/m cu)
I HAVE APPLIED FOR 20TH UES ARMY. I WANTED TO KNOW WHEN WILL I RECEIVE CALL LETTER FOR THE SAME.
In how many types u can do POP on ceiling and walls(on which material or by using which material)? b) what is the difference between dry , oil bound, enamel, acrlyic type of painting? 2nd :- I have certain queries, please help to solve. a) length of pile bore is 4m.excavation quantity will be area * length where area will be pi/4 * dia*dia. Is this right? b) It is a single reamed pile of 300m dia and reamed dia is 750mm. can any body help me to calculate excavated quantity of this bulb(reamed section),, concrete quantity in bulb with showing the formulas to be used?
For making a new road in a village having a school & hospital , tell the steps of construction systemically ?
what might be the problem faced in the near future if the M-sand is used in the place of river sand during wall plastering? (As per IS)
Explain the difference between shear and tensile strength.
Define What is a projection line?
how to stop beam concrete between column
