Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / silamparasan p.
POwer Factor is a cos angle between Voltage and current.
| Is This Answer Correct ? | 51 Yes | 6 No |
Post New Answer View All Answers
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
What is dynamo function in DG sets and draw block diagram?
what is the purpose that we use PLC system in power system
what is meant by 2 within a star in a voltmeter dial?
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
what is difference between elr and R eartl realy.
what material is the electrical housing wire made of? is there any difference for the telephone lines?
Diagram on interconnectivity of 11kv transformer with RMU (i.e, one incoming and two outgoing or two incoming and one outgoing)
My load is 1635 KW. & current pf is 0.884, I have to improve it for 0.99.Please suggest what KVAR value is needed?
What is open loop and control loop systems?
application s to shunt coil
How cable from Kit-Kat to main switch, from starter to motor are designed?
In diesel generator how AVR get voltage to excitation. And basic diagram DG EXCITATION CIRCUIT.
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
why to use freewheeling diode ( diode in revers bias mode) across dc coil
