Interested to Buy Any Domain ? << Click Here >> for more details...
why the generating voltage in India is 11kV or why is it be
transmitted as multiples of 11
- 34 Answers
- 122768 Views
- ACC, Bhel, ECI Engineering and Construction, NTPC, SBL, Senthur Power Services, I also Faced
- E-Mail Answers
Answer Posted / chandru_williams
I srrongly disagree with Kavitha. Insulators are made only
for the volateg ratings produced ( 11KV). The actual reason
is as follows.
1. When an alternator generates voltage, its rms value is
given by 4.4*f*$*t, where $ is value of total flux per
pole. So we can see all the voltages are made inevitably
multiple of this value (1.1, which is the form factor of
ac wave). Also it provides us the best economic
construction of step up and step down transformers.
2. We always use a multiple of 1.11 bcoz for a pure sine
wave the FORM FACTOR is the ratio of rms value of voltage
or
current with the avg. value of voltage or current and for
pure sine wave rms value of current is Imax/root '2' and
avg. value is 2Imax/pie. and which comes out to be 1.11 so
we cant have a combination of other then a multiple of 1.11.
| Is This Answer Correct ? | 20 Yes | 9 No |
Post New Answer View All Answers
Which type of transformer is used for lighting loads?
what is the difference between linear choke and suction choke?
On 400 amp factory load how kvarh capacitors provide
What is force on a conductor in a magnetic field ?
what is plunger and what's the use of it in motor alignment?
along with technical test papers
What is the difference between Droop vs Isoch Control?
What is the formula to calculate the rating of a three phase miniature circuit breaker
What are the two types of compensation?
Give me the calculation steps to design an electromagnet to be work in 230V 50 Hz AC Supply. Also give force that is created by that electromagnet when it gets energized.
Why frame of the motor is specified?. If we mention KW and voltage level,automatically frame is decided or separately frame is compulsory to mention?.
Explain the functioning of diode?
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
i applied for c licence with my one year apperents trainee and i have attaced with A grade contractor company experiance that is for 14 monts experiance this document is sufeicant for c licence? pls tell why they rejected
15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help
