Answer Posted / guest
Transformer has a lv which is subjected to low voltage
where as
hv wng is subjected to high voltage.
Now on a transmission line voltage vary according to load
demand.
Now if we placed the OLTC in lv side then it is very
difficult to changing the tapping inside the trasformer
accodingly to the load demand.
Now if we placed the OLTC on hv side (which is outer side)
so we can easily change the tapping accordingly the load.
Hence ON LOAD TAP CHANGER PLACE OUTER TO (hv) IN
TRANSFORMER.
| Is This Answer Correct ? | 3 Yes | 11 No |
Post New Answer View All Answers
why normally Generator rating are between 11Kv to 22Kv?
Why does an induction generator is preffered as compared to synchronous generator in especially a wind energy power production project?
What are the different methodes for calculating the short circuit Current?
explain single phase series motor
What are diffrent type of road taxes?
What should be current in the Primary and secondary side of 1000KVA (11KV Supply)Transformer.?
How many types of electrical earthing are there?
what is the condition for YnD11
How do u analyse protection fault when vcb tripping on load
what is the k var ratting of 1250kva
my UPS suddenly goes off and all panel light also blow off.This happens even main electric supply is not interrupted.After some time it automatically starts functioning normally.Batteries are new.
should %impedance be high or low in a power transformer? if so why?
Can any body tell me about INNER SHUNT COMPOUND MOTOR diagram?
Explain with example of functional requirements of protection relay in terms reliability, selectivity, sensitivity
Explain the laying procedure and laying depth of submarine/subsea power cable for 220/400KV system? Also available cable diameter?
