Interested to Buy Any Domain ? << Click Here >> for more details...
Why we use 250 ohm resistor in series with HART protocol
communication?
- 13 Answers
- 58773 Views
- Chemtrols, Instec, Sabic, I also Faced
- E-Mail Answers
Answer Posted / preyas
Becoz DCS is given the signal in terms of voltage(1 TO 5 V).
And V=IR,
Now Whwn I=4ma
V Should be 1 V
putting in V=IR we get r=250 ohms.
Same in case when I=20 ma
and V=5V WE GET r=250 ohms.
| Is This Answer Correct ? | 124 Yes | 23 No |
Post New Answer View All Answers
What is difference between differential pressure & delta pressure?
How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?
What is Alpha & Beta fctors related to Orifice Plate & its relation with flow?
How you calibrate absolute pressure with the calibration range of 0 to 1000 0C Absolute. Please explain the procedure for calibration.
what is compensation? temprature & pressure
Draw symbols of the following :
Why the ammonia and Nitric Acid level indicators is with millimeter ? and What is the conversion form millimeters that level indicator indicate to weight ?
HOW TO CHOOSE FREAQUENCY IN FMCW TYPE RADAR INSTRUMENTS. DESIGN BASIS OR DESIGN CALCULATONS ?
selection of the zener barrier for the hazardeous area zone 0
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?
how can i calibrate the temperatuture gauge used by temperature bath(dry block) i mean step by step procedure?
Draw a wheatstone bridge circuit showing supply, meter and 3 wire RTD connection
What are the different types of thermistors used in industries? How to the operation of typical thermistor?
Derive capacitance to 4-20ma conversion formula / relation in capacitance type pressure sensor?
