Interested to Buy Any Domain ? << Click Here >> for more details...
why the flooring of substation is done with small pebbles or
stones..?
- 16 Answers
- 43359 Views
- I also Faced
- E-Mail Answers
Answer Posted / amit maindoliya
its to get an earthing system...and off course to protect
system from lightning strike too.
| Is This Answer Correct ? | 0 Yes | 11 No |
Post New Answer View All Answers
Is there any type of starter for DC motor other than two point,Three point and Four point starters?
what reactive how to maintain
Dear all, I just want to ask an expert on this forum for some insights. For the magnetic balance test, when applied voltage on a Delta-Star transformer e.g. Dyn11, the following relationships apply for HV side: 1. H1-H2 = H2-H3 H3-H1 2. H2-H3 = H3-H1 H1-H2 3. H3-H1 = H1-H2 H2-H3 For the LV side also: 4. X1-X0 = X2-X0 X3-X0 5. X2-X0 = X3-X0 X1-X0 6. X3-X0 = X1-X0 X2-X0 Is there a similar pattern for Y-d, Y-Y, D-d? And how about Y-z, D-z, Z-y transformers? I've tested a YNzn5 transformer and for LV side I don't see the pattern. In this particular case I got for LV side the following (see values below): H1-H0 H2-H0 H3-H0 X0-X1 X0-X2 X0-X3 128.0 119.9 7.2 29.2 13.3 15.8 70.7 128.4 59.2 23.4 22.0 3.6 7.2 120.1 128.1 13.4 29.3 15.8 What is the relationship here for LV? For row 1 I see the relationship, for row 3 I also see but it's shifted, but for row 2 I don't see such relationship. Any suggestions, answers, someone?
What will happened if the neutral of the (star connected secondry) Xformer disconnected? (if its Above KVA rated one)
is it possible to start a motor in felid connected to a remote mcc
HOW TO CALCULATE EARTHING SIZING?
If I want to buy a new Xformer for my plant what are the main parameter will I need to check?
HOW TO CALCULATE AMPs OF CURRENT TRANSFORMER IN HT Panel
How can we calculate cable size in Low voltage & high voltage
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB Machines of higher rating?
Transmission through a short line depends on
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
defult setting in p220 micom motor proction relay for 11kv,640kw,f.l.a.-40a,1440rpm ht motor?
l&t switch FN 63 handle position can we change
What is the universal motor?
