Answer Posted / singo

for hpcl go trough o.p.gupta for technical paper, and for
apptitude follow r.s.agarwal.

Are there any general rules that should be considered when designing a slurry piping system?

1041

---

Explain what is the significance of the minimum flow required by a pump?

1227

---

Explain the steps required to design a vapor-liquid separator or flash drum?

1078

---

What are the factors involved in considering the choice of dry screw compressor?

1059

---

Is there a rule of thumb to estimate the footprint of a cooling tower during design phase?

1299

---

Re: Sugar Cane Bagasse What are the 1. Specific Heat of Bagasse at 50% moisture, 40% moisture and 25% moisture? 2. What is bu;lk density of bagasse at 50% moisture, 40% moisture and 25% moisture? 3. What is specific gravity of bagasse at 50% moisture, 40% moisture and 25% moisture? 4. What is the specific heat of flue gases generated from boiler fuelled by bagasse? 5. What is the specific gravity of flue gases generated from boiler fuelled by bagasse?

10093

---

I want previous year question paper of ONGC for chemical engg.

2255

---

what is defferance between tubular & automotive plate battery

4103

---

Explain what type of flow measurement devices is best for slurries?

1068

---

What is a good source of surfactant information on the internet?

1294

---

how we can find solubility of liquid in amyl alcohol and relative solubility of amyl alcohol

1652

---

What is difference between Piping Standard & Piping Specification ?

2525

---

how much maximum power can be generated by 320v, 10kg-cm synchronus motor if shaft is roteted mechanically at 50 to 60 rpm?

2334

---

pleas tell me about chemical engineering apptitude test..

2342

---

Explain the some guidelines for sizing a psv for a fire scenario on a vessel in a refinery service?

1150

---