Answer Posted / r.kannan
1.main purpose to balaning voltage,
2.To protech alternator from fault
| Is This Answer Correct ? | 19 Yes | 1 No |
Post New Answer View All Answers
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:
what is the difference between elcb and rccb ?
how to calculate the fault in substation
cc of scorpio?
how does it help for selection of a transformer.
explain all the classes with example
How much costly in percentage wise is sandwich busduct costly than air insulated busduct of any rating?
i am in need of AC SYNCHRONUS MOTOR 30KW. ANY ONE KNOWS THE MANUFACTURER OF SAME. ALSO MOSFET AC CONVERTER 20KVA CONT.OUTPUT.
Comparision of Air break circuit breaker, SF6 Circuit breaker and vacuum circuit breaker.
if we run a 3 phase machine on two phase what will happend??? given answer with solid reason please
When semiconductor fuse does save thyristor in each cycle of conduction? Why under voltage setting keep less in SPRS and more in DC drive?
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
why incomer bay is required before transformer bay if there are more than 1 nos. of transformer bay.
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
