In a three phase transformer(delta/star connected)when i
touch one end of the bulb in any one phase and other end to
earth..will the bulb glow or not..if not why?..i'm touching
the bulb in star connected side...
- 6 Answers
- 7858 Views
- I also Faced
- E-Mail Answers
Answer Posted / vksumith
secondary(star connected) phase voltage is 110v and line
voltage is around 230v..
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
explain wiring system
Why only sinusoidal ac voltages are generated?why not triangular or sawtooth?
How will calculate losses in an multi core Aluminium LT cable of different sizes & upto what length we can use a LT Cable ?
How cable from Kit-Kat to main switch, from starter to motor are designed?
what is the reactance,capacitance & impedence electrical armoured & unarmored Cables.
what is the difference between general inverter and solor inverter clerly explain plz
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.
If mutual flux is 1.2wb & power factor is 0.8 lag , then what is the Useful flux of a transformer?
What is Delta Connection? What is meant by Forward Delta & Reverse Delta & How Will be the Connection in Power Transformers?
what is sevice settings for mccb?How can be it setted?
How does the phase sequence controller works, how it identifies the phases? confirm working principle
a 230v transformer with step down ratio 19:1.it has 2000turns on primary and rated 25va calculate max primary current no of secondary turns volts/turn
Type of motor stater detail and working detail
what is the practical application of full adder circuit?
