how will you determine the short circuit capacity of a
network
- 3 Answers
- 7892 Views
- Dalkia, I also Faced
- E-Mail Answers
Answer Posted / vinay sangwan
If we know the total impedance of the network then we can
calculate the short circuit current.
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
The power supplied to a 33microF capacitor from a 120V, 60Hz source will be
In single phase capacitor motor, if the motor rotate reverse direction then how much power will be consumed by the motor and why?
If any HVDC line is going with positive & negative(the negative usually have return path of current with earthing electrode). Now the question is if this HVDC earthed electrode which is using as return path and earthed any nearby 400kv or 220kv AC substation equipments. which will be the impact of this on AC substation & its equipment, how severe may be this and what should be the minimum distance require between HVDC earthed electrode and AC substation equipments? It's really an high engineering level question...Dare to answer and increase your knowledge.
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
tell me about roaster switch .& what is the function in transmission & distribution?
What are gain margin and phase margin?
how to modify DOL control panel into Delta Y connection?
Why dry type cast resin transformers tap link blast in HV side while power shut down times on load?
Why can't we parallel the secondary circuits of two voltage transformers?
how to calculate the torque of a motor?
What are the ratings of VCB, MCB, MCCB, SF6, ACB, and OCB?
The power factor of the fixed load is 0.8, now the p.f is varying from 0.8 to 0.5.
how to remover corona effect and hysteresis losses from contactor
what would happen if reactive power (kvar)is increased (more)or decreased (less)? how much exact reactive power should be maintained? and what should be done for that
what are the stresses in circuit breakers ?
