Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sripellirajukumar
hi ,
this is rajkumar
u were said about r very silly points
here somewhat depth differences there as follows
current transformers
1.primary winding turns r very less .
2.CT means it is step up transformer.
3. the primari and secondary winding turns ratio is in the
form of 100:5.
4.this CT is used to measure currents in high voltage
alternating current ckts.
5.secondary winding of CT must be closed.it should never be
left open under any circumstances..other wise it CT
winding insulation will damage,and also that will effects
on the people who r doing the measurements.
potential transformers
1.primary winding turns r more as compared to secondary turns
2.PT means it is step up transformer.
3.the primary and secondary winding turns ratio is depends
on the range of lowrange voltmeter (which is used to
measure voltages in lab)
4.PTs r used to measure high alternating voltages.
5.here no need to specify about closing of PT because we
will be connecting low range voltmeter...
thanks,,,,,,,,
| Is This Answer Correct ? | 11 Yes | 11 No |
Post New Answer View All Answers
How the capacitance og capacitor volatage transformer is decided?
In Designing the rating & accessories of a MCCB how to choose the type of releases..means what is the basis for selecting, thermal magnetic, electromagnetic & microprocessr based releases
if 12v battery get discharged for 2 months after if we put charge it will charge again?how much time it will take to charge?
How generating electric power export to grid from the generating station ?
For refrigerators the motor current is raised beyond its rating on both conditions when the voltage of the system is more(say 270v) than the rated voltage(220v) as well as when the voltage of system is less(say 160v) than normal voltageof 220v, why explain?
For a spring controlled governer the relation F = ar+b (F is the controlling force, r is the radius of rotation a and b are constants), indicates that the governer is
in Telecom DC system-why positive +ve is made earthed.and - ve is fed to load.
Define non-touching loop.
how can i improve the power factor in domestic (230v)
What is the principal of motor?
What is lifting power for 1 wb/m2 and 1 A magnet?
What is Faraday's law
What are steps to be taken while designing of DYN11 distribution transformer to achieve magnetising balance?
Is it acceptable of installing an earth pit in planters area where bare copper cable, earth rod and connection are susceptible to corrosion due to water?
When is lag lead compensator is required?
