Interested to Buy Any Domain ? << Click Here >> for more details...
I have 725KVA DG set how to Calculate the Ratio of KWH?
Whatb is the Formila
- 7 Answers
- 28760 Views
- HCL, I also Faced
- E-Mail Answers
Answer Posted / jagjeet
power=1.73*V*I*p.f kwh*efficiency
V- Average voltage per hour
I- Average current drawing per hour
P.F- Average power factor per hour
| Is This Answer Correct ? | 7 Yes | 10 No |
Post New Answer View All Answers
Explain Continuous and Discrete signals?
how to calulate short circuit current for the following: 1.cable connecting 11KV of 22KV/11KV transformer to 11Kv of 11KV/415V transformer 2.what cable size should i use.
lorteny method
All tape of electrical questions Answers tape of motor transformer e.o.t crane
What is transformation ratio what it describes?
why the value of k is more in shell typr transformers?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
Dear all i want to know SEWA Electrical Supervisor Licence test Previous Year Questions ? If any body know please send to me zohairaukllah@yahoo.com
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
what is meant by re-rolling motor? how it differs from standard motor?
why ct's&pt'S out put called as burden,why compelsary short ckt the secondary of ct's while removing the burden?
WHAT IS MEANT BY DERATING OF THYRISTOR?
draw vector diagram and +ve,zero sequence diagram of symmetrical three phase fault.
How generating electric power export to grid from the generating station ?
What is the name of transformers oil filteration equipment?
