Interested to Buy Any Domain ? << Click Here >> for more details...
in india,we use 230V,50 Hz,whereas many other countries use
110V,60Hz.what r d advs and disadvantages of each of them?
- 11 Answers
- 28129 Views
- I also Faced
- E-Mail Answers
Answer Posted / jagjeet
If human safety has to be consider than definately 110
voltage system is more safer than that of 220 volts
| Is This Answer Correct ? | 36 Yes | 18 No |
Post New Answer View All Answers
Explain thin film resistors and wire-wound resistors
Why dry type cast resin transformers tap link blast in HV side while power shut down times on load?
What is the effect of atmospheric pressure & Temp; on efficiency of motor? Why NGR(Neutral Grounding Resistor) is used in 132/11 KV Transformer & how? What is the use of Auto T/F in Grid Station?
A 50Hz,4-pole,3-phase,star-connected synchronous motor has a synchronous reactance of 12ohmsper phase and negligible armature resistances.the excitation is such as to give an open-circuit voltage of 13.2kilovolt.the motor is connected to 115kilovolt, 50hertz supplying. what maximum load can be the motor torque,line current and power factor?
If two Transformers are connected in parallel having impedance of 50KA in both transformers will the impedance increase or decrease after connecting transformers in parallel?
What are the functions of different probes used in cro?
What is the method of estamating of cable, CB,MCB ?
Show the schematic arrangement of diesel power station layout and give its principle of operation.
What are the section criteria for cables. Now everywhere XLPE power cable is used or PVC is also used?.
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
Why Neutral Isolation is required?
What is the loss of power of transformer 220kv/33kv,63/80mva of % imp12.05 at 80%load
What is the approximate value of stacking factor?
what is the constructional difference between a power transformer and potentian transformer?
What is difference between start imitation and start interlock for 3 phase motor protection ?
