Interested to Buy Any Domain ? << Click Here >> for more details...
WHY TRANSFORMERS ARE RATED IN 11KV 22KV 33KV Instead off
10kv 20kv 30kv
- 5 Answers
- 23033 Views
- I also Faced
- E-Mail Answers
Answer Posted / chandru_williams
1. When an alternator generates voltage, its rms value is
given by 4.4*f*$*t, where $ is value of total flux per
pole. So we can see all the voltages are made inevitably
multiple of this value (1.1, which is the form factor of
ac wave). Also it provides us the best economic
construction of step up and step down transformers.
2. We always use a multiple of 1.11 bcoz for a pure sine
wave the FORM FACTOR is the ratio of rms value of voltage
or
current with the avg. value of voltage or current and for
pure sine wave rms value of current is Imax/root '2' and
avg. value is 2Imax/pie. and which comes out to be 1.11 so
we cant have a combination of other then a multiple of 1.11.
| Is This Answer Correct ? | 26 Yes | 4 No |
Post New Answer View All Answers
In how we connect watt meter for open & short circuit test of a single phase transformer.
Explain difference between stand by earth fault and residual earth fault protection?
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
how many parameters can integrate with fire alarm basically ?
whatis the commertial spec. of distribution boards ?
delta motor winding resistance I take normally single winding is 2.5, which value is came delta connection ie RY ?
What will be the voltage impact on secondary side of two transformers with different vector groups when both voltages are compared.
Atwhat condition reverse power relay will act?
Difference between megger test equipment and contact resistance meter test instruments?
True or false question. 1.The fuse provide phase and neutral 2.power loss in electrical circuit can take place in (resistance or inductance or capacitance). 3.two phase system each phase has separated by a phase difference of (90 or 180 or 270 or 45). 4.3 phase balanced star connected load neutral current shall be (line current or phase current or zero or unity)
what will be happen if earth point is being used for as a neutral point for raw power , and same will be used for ups earthing
How to set the relay,,??
please send me latest & previous years question papers for IOCL Technical level questions
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB Machines of higher rating?
If oil and air can withstand a high MeV when used as an insulator in a transformer, what are the values of how high for each material?
