Interested to Buy Any Domain ? << Click Here >> for more details...
Why the Proximitor supply should be Negative voltage? Why
should not we give Positive voltage to the Transducer?
- 6 Answers
- 16108 Views
- Moser Baer, I also Faced
- E-Mail Answers
Answer Posted / grajesh
Because Proximity will induces the Positive field
| Is This Answer Correct ? | 2 Yes | 11 No |
Post New Answer View All Answers
how to relay switch sense the fault?
Why use ball valves on Gas pipelines instead of gate & or globe valves...means basic diffrence or use of these valves..how designers knows this type of valve with rating is required...
Isometric drawings are generated during _________________ phase of a project
what will the sending unit in the fuel gauge utilizes?
Describe how to use megger to measure the earth resistance and insulation resistance
hi! i want to know about mpse exam.
KAlman filter code for two dimension?
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
where proximity sensor installed on tank in loading arm application
What is the start up procedure of desalter
what is diffrance between FF & SMART, explain with difination
how to calculate control valve bonnet size?? or how to select its material?
what is Best Among SINK Or SOURCE Type Design In Digital Signal, Either Iput Or Output? WHY?Can any one..
what can of fault ofently come in vibration mesurement?
the output of the common trasmitter protocol in qatar gas are the following
