thermal power station operation in general
- 11 Answers
- 30358 Views
- AJ Square Inc, Jindal, NTPC, I also Faced
- E-Mail Answers
Answer Posted / ravi
In thermal power stations coal is burned in a vessel called
Boiler and the Boiler is made up of number of tubes through
which water circulates continously. And this water converts
in to steam, this steam is allowed to passed through the
blades of turbine. this turbine roatates Generator by
fixing generator and turbine on a common shaft the
generator rotates and E>M>F will be induced and as
faraday's law current will be generated.
| Is This Answer Correct ? | 33 Yes | 9 No |
Post New Answer View All Answers
What are the characteristics of negative feedback?
how define the torque in ac drive. from electrical side in the drive friquency ,voltage and current three factor is there.
In the N-series schneider reclosers. What is the difference between current during fault time and current at tripping? This appears in the Event log in an event of a trip out.
If rotor works in clock wise what happens
What is pi controller?
how to i get B licence,i am completed BE electircal and electronics engineering.i want to konw the proceduure to get b licence
Why front mounted CT polarities are always towards breaker?
Please give me a erda placement paper
draw the restricted earth fault protection circuit install on power transformer and identify its parameters and draw C/C curve of it
delta motor winding resistance I take normally single winding is 2.5, which value is came delta connection ie RY ?
what happens to the supply voltage if there is any change in frequency?
What is the RMS and DFT principle of analogue maesurments. Which way they are advangages. where which princples give optimum results.
i want to know how to determine that a surge arrester work properly in 11kv system. and how to test a 12kv surge arrester
Why an ac systems are preferred over dc systems?
how to extend relay operating timing in 24V dc relay card (without using Timer )
