what happen if position of GNA and MNA is changed in
machine?
- 3 Answers
- 8028 Views
- I also Faced
- E-Mail Answers
Answer Posted / kalidass
There is voltage drop due to armature reaction may happen
| Is This Answer Correct ? | 7 Yes | 3 No |
Post New Answer View All Answers
how we find transformer capacity by ohm
what is meant by CT`s saturation ? Can we use Metering CT`s with Protetection CT`s ?
I want to know all basics of electrical engineering
How many types of interlocking use in screw type air compressor,make-Kaser(BSD MODEL)?
How to find ampere on ht side for selection of cable size ???
I have a relay contact rated at 220v dc which is supplied with a 24vdc from the panel,for it to trip the dampers(24vdc).What if the application of the relay changes so that it should work at its rated 220vdc then will it work at 24vdc supply given or any other consideration needs to be taken .....
sir vizag steel ka junior trainee ka paper kitne number ka ayega
sir, i'm preparing for hpcl exam officer trainee pls tell me how the exam ques paper pls pls
1.4 What is meant by CT knee point voltage and how would you determine it
Discribe type of fault in DOL and stardelta startor.
why chock were used in old tubelights but are not newest tubelights?
In Plumbing services What are accessories we consider for a bathroom?
Ac generato how produce power I need for camplet defination
What is a differential amplifier? Also, explain cmrr.
Which device of PlC does share load between DG sets when DG are running in perallel?
