In case of a beam ,main steel is provided along the longer
span because, bending moment is directly proportional to
length but why in case of one way slab main steel is
provided along shorter span while as bending takes place
along longer span?comment
- 8 Answers
- 19452 Views
- Power Grid, I also Faced
- E-Mail Answers
Answer Posted / shanmuga sundari
in case of beam b.m takes place along the lenth so main bar
is provided in tat direction to resist b.m.but in case of
one way slab the bm along longer direction is too low as
compared to shorter direction so resisting this bm
distribution bar is enough.so main bar is provided in
shorter direction and also l/b ratio is greater than 2.
| Is This Answer Correct ? | 4 Yes | 4 No |
Post New Answer View All Answers
how much cement is consumed by a stone masonry wall 17.7m long,0.55m wide and 1m high
How do you convert wind speed into force?
If 40 backlogs are cleared m finally with 65 percent marks . Am I eligible to get visa to US
What is the difference between Grade I, II and III of GSB?
why is M25 and Fe 500 assumed to be most economical? i feel it is not.This is because higher grade of concrete and steel has higher lapping length and anchorage length compared to lower grades..
what is the difference between tsp & tower
Design a built-up column carrying an axial load of 1200 KN. Its length is 8m and it is effectively held in position at both ends and restrained against rotation at one end. Assume yield stress of 250 mpa
psc girder detail
What is the standard unit weight of Cast Iron pipe of 200MM Dia.(pipe specification is IS1538)
A super elevation of 60 cm has been provided on a 8m wide road and a curve of 260m radius .calculate the max.speed in km/hr of the vehicle that can be negotiated safely? Plz answer with full solution.thanx
how do you calculate the length of "L" of main & distribution bar for reinforcing of raft footing
Why should appointment store person for project ? what is the benefits for company ?
How to calculate the cement and fine aggregate requirement for solid block masonry works in terms of Sqm. 1. 400x200x200mm 2. 400x200x100mm 3. 600x200x100mm 4. 600x200x200mm I need the answer for 1 Sqm of solid block works.
How to calculate canal slope curvature qty!
100mm block work 64 bags of cement used 150mm block work 286 bags of cement used 200mm block work 20 bags of cement used patly work (M15) 293 bags of cement used mortar ratio is 1:5 how to calculate volume of sand in cum & no. of bags
