Interested to Buy Any Domain ? << Click Here >> for more details...
All Rector or Exchanger have spherical/hemispherical end
Why?
- 2 Answers
- 8489 Views
- Reliance, I also Faced
- E-Mail Answers
Answer Posted / nagarajan
Its in order to reduce the internal stress of the working
substance.
For eg., If Water Vapour Dry is the working substance in
the reactor or boiler and if the ends are square, at the
corners there are possiblities of pressure shoot up and
also possiblity of more pressure concentration at those
points. in order to avoid that, Spherical/Hemispherical
Vessels are used.
One more place where Spherical vessels are used for storage
is LPG Storage Containers
| Is This Answer Correct ? | 34 Yes | 1 No |
Post New Answer View All Answers
hi friends kumar here if anybody of u have " INDRAPRASTHA GAS LIMITED" placement papers than plz send it to me i need it urgently..ok mail id is ashish_me2007@yahoo.co.in
How is propeller fitted in shaft?
What should you do before you start the engine?
What is breather frequency of tank?
Which reactor uses primary coolant as fluoride salts of lithium, beryllium, thorium and uranium ?
I heard that the acetylene cylinder pressure can't be brought down below bar while using for welding activity. Is it true. . If so pl explain why
I want to apply for Asst.vehicle inspector,i would like to know the requirements and the syllabus.. if any body know that please mai me.. naany4u@rediffmail.com please friends
Low water in boiler drum is unsafe because it may result in overheating of water tubes in furnace. Why it is unsafe to have high water condition in boiler drum ?
what is the techanical difference between german standard & japanese standard.
Please any one help me I preparing for the post of charge man in Indian ordinance factory please give me some guide line & book for this exam.my email. anoopkpandey16@gmail.com
Explain the opening and closing of water to the bowl of the purifier
What is the thermal efficiency of a diesel engine?
Draw the flow of F.O. diagram from service tank to Main Engine?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
Whether individual components in composite materials retain their characteristics or not?
