Answer Posted / nihar ranjan sahoo
Fuse is an equipment used to protrct the circuit,in case of
over current,short circuit conditions.When this type of
fault occurs in a system, maximum fault current flows in
phase wire.so only in phase wire FUSE is connected.
| Is This Answer Correct ? | 12 Yes | 28 No |
Post New Answer View All Answers
distribution transformer de-rating formula on over limit iron losses
I need bhel electrical test pattern & paper
how to calculate current carring capacity of cable and cable selection? 1) copper flexible cable 2) copper armoured cable 3) Aluminium cable
What is meant by turbo alternators?
1.What will be stored in online ups EPROM IC?
why voltage form factor of PT are increase , when it is ecpected heigher spikes in system. how it is calculated.
when 20hp 3 phase motor start no load condition in star or delta connection.find current and write formula.(tariq)
how open delta PT works & what is its construction?
I have a current transformer with 1 main reading meter with transformer outside the building and a control panel having 5 CT reading meters with black round coils inside the building. I want to know, A) when current pass through the Transformers, will the current be reduced or be the same and after that B) when current pass through the CT meters with black round coils, will the current be reduced or be the same. C) in the above process will the reading of the main meter be same or different, from the total reading of all the 5 CT meters.
Is any AC drive(VFD) had a feature of DC injection braking? if available please mention the detail. i.e drive can supply braking torque when the motor in idle state.
what r the checklist while installing a 380 kva DG set
Why have to use copper cable for local isolator to motor ?
132/66kv sub-station procation ?
what is your majour contributions in your present job
How the setting of the vector surge relay shall be calculated when the relay is to be used for Grid islanding application?