Interested to Buy Any Domain ? << Click Here >> for more details...
what r the types of detectors? state the location these
detectors?
- 3 Answers
- 6165 Views
- I also Faced
- E-Mail Answers
Answer Posted / bmw6633@gmail.com
smoke detector:these r used in anywhere in a closed area,
heat detectors:these r used in labratories,
sensors:used in m/cs ,atomatic door open when an object
stand in some distence to where the area of detection is set
for.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
What is the difference between PS & metering CT (5p20,0.5 etc.)? Why in PS class CT only Vk is given ? Is PS class CT is more accurate than metering CT?
why should the lowest unit of a testing transformer ( cascaded transformer ) have higher power rating??
Dear all, I'm manikandan I have done by DIPLOMA EEE from 2011 , I have 5 years of experience from Power plant instrumentation field , which one field is give long life & which one field is best ,I confused a lot and also I'm studying AMIE, can I choose which department from Section B examination? pls tell me
WHAT IS IEC? & WHAT IS BENEFIT TO PRODUCT FROM IEC?
What is the difference between UPS & inverter ? which UPS is better and whos got the edge ? what is the difference between & inverter ? which UPS is better and whos got the edge 12 V , 24 V , 36 V etc what are the advantages of 12 V, 24 V , 36 V etc and what are the disadvantages of 12 V, 24 V, 36 V etc thanks
How eddy current generation support the idea of train braking?
How 48-relay (incomplete sequence) functions?
in non technical way how can u define POWER FACTOR??
What are the types of piano switches?
What are the differences between single phase and three phase?
What is the slip speed?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
Thermal withstand capability under full short circuit conditions, in terms of number of times of occurrence of short circuit and corresponding anticipated percentage reduction in transformer life.
why constant voltage transformer should be start without load? and if started then what will happen?
On Which Pressure PRV is operated.
