Interested to Buy Any Domain ? << Click Here >> for more details...
Can any body tell me what is use of END OF LINE RESISTOR in
fire alaram circuit?
- 2 Answers
- 7223 Views
- I also Faced
- E-Mail Answers
Answer Posted / pratheesh
I dont know excatly the use of end off line resistor in
Fire alarm system.
But in communication system(Profibus) we use end off
line resistor. In this system, all the communication
devices connected to the same bus in parallel. The bus
having only 2 wires and all the devices connected to
this same 2 wires in parallel.. And each communicator
devices have one address in that bus. Thats how the
server identifies the signals from that particular
device. So the extreme end of this bus cannot be kept
open. By providing an End Off Resistance, server can
know that this is the end of the bus and there is no
devices from that particular point.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
1.how many types of relays? 2.difference between ATS& STS?
What is the difference between isolators and electrical circuit breakers? What is bus-bar?
Explain thin film resistors and wire-wound resistors
what the Microsoft .NET framework is?
Yazaki india pvt ltd interview questions qurey related
What id difference between power and energy?
what is the importance of earthing system on the generators big capacity and small?
what is the difference b/w ATS and HTS?
What is EMC filter in VVVF Drive ?
there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit
We normally make oil soak pits under Transformers. Oil from soak pit goes to collection pit. We provide granules/pebbles under transformers. My question is weather granules/ pebbles to be filled in soak pit or not? if yes upto what level?
how we explain parallel paths armature winding?
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
How LT megger works ?
what are the things that can cause a three phase motor to crawl?
