Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / pratheesh
if an induction motor starts directly online, it will
take very high starting current(Approximately 6-8 times
of full load current). For small motors, this starting
current is not much. But if the motor is large one, it
will draw a very huge current thats how a voltage
fluctuation(Sags) will be created in the electrical
system in which motor is connected.This voltage sags is
not at all desirable and it may affect the other
equipments connected to this same electrical system. And
also this huge current may damage the motor itself.
So by connecting the DELTA wound motor in STAR, the
applied voltage to the motor winding is reduced by
1/1.173 thats y the current drawing by the motor reduces
to 1/3.
After 6-10 seconds(Motor will reach almost its rated
speed within this time) the star connected is removed
and will be connected as delta. So the motor can carry
full load in delta.
There are other kinds of startes like, Auto transformer
starter, Resistance starter etc.
| Is This Answer Correct ? | 36 Yes | 3 No |
Post New Answer View All Answers
How would you calculate power loss in a resistor?
How do i perform grounding of star point of Genset (400V) for making connection with step up transformer of DELTA-DELTA (400V to 20KV) ? while Genset itself has its own neutral and grounding bus bar inside genset breaker box whereas we have another neutral and grounding busbar in synchronizing panel next to genset at maximum distance of 6meter, would someone pls advice if we can only perform neutral grounding in synchronizing panel or should we ground neutral on both places inside genset breaker box and synchronizing panel.
What are the major reasons for balancing hydro-thermal mix?
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
How phase displacement change in the over current relay coils.
why the India electrical supply transmission loss is high when compare to us
Briefly describe means used by electricity suppliers to influence the flow of active and reactive power in power networks (one for each type)?
what is tri state logic gate
explain transformer ct connection?
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
All tape of electrical questions Answers tape of motor transformer e.o.t crane
How Can you do Maintenance of ACB of 2000Amperes
Why Utility Distribution System in India is mainly at 11 kV? Why not Utility go for 33 kV?
why we not used 11kva as a direct our electrnics component.
What is I to C?
