Answer Posted / naresh
Single Phase meter is a measuring instrument which records
the power consumed by the load in terms of 'KWH'. The meter
records the consumption based on the following formula...
Power in KWH = Voltage x Current x Power factor x Total
number of Hours utilized.
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
apti mainly on logical reasoning, verbal and non-verbal ability (70 percent) and remaining technical. I was in ee but technical had mech ques like on turbines and welding.
In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is
what is LSR?
why are the maintaine power factor and how can this control and this is how work.
derive DC RMS value for half wave rectifier?
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
why cable i burning without tripping. how can protect led street lights
what's the requirement of Dy11d0 connection of 3 phase transformer?what's use of it?
what is the use of surge suppresser in 33 KV incoming panel. where it must be installed,inseries with incoming cable surge suppresser must be at incoming of the breaker are outgoing of the breaker
WHY IN AC DRIVES,INPUT PHASE CURRENT SHOW UNBALANCE?
Compare jfet’s and mosfet’s.
What are the common sources of energy?
how to calculate short circuit current for the busbar
What are the two segments of nyquist contour.
WHAT IS THE FAULT WHEN 100HP TURBINE MOTOR TRIPS, LIST THE FAULTS AND ITS TRABULESHOOTING TIPS.. MY AUTO TARNSFORMER STARTER TRIPS
