Interested to Buy Any Domain ? << Click Here >> for more details...
I have 725KVA DG set how to Calculate the Ratio of KWH?
Whatb is the Formila
- 7 Answers
- 28157 Views
- HCL, I also Faced
- E-Mail Answers
Answer Posted / bala
power=1.73*V*I*p.f kwh
V- Average voltage per hour
I- Average current drawing per hour
P.F- Average power factor per hour
| Is This Answer Correct ? | 23 Yes | 16 No |
Post New Answer View All Answers
can the measured percentage error during calibration of single phase energy meter be negative?
How to calculate the sag on transmission Lines.
Whether the vacuum contactor requires Short circuit protection?If No,why?
any application of back emf
Define filter?
If we use 250A MCCB as a incomer in Control panel for a fault level of 50kA for one second ,assuming temperature rise from 85 Deg. to 100 Deg , Then what will be the Aluminium Bus-bar size for 250A MCCB? Explain in detail.
What is the importance of counter based plan & how is it scheduled?
how much LT load can bear by the 100 KW HT connection.
what is the importance of Partial Dischage test for Electrical Equipments
we have two motors 1250kW,6.6kV to be coupled on the same shaft ,so please provide assistance for their synchronisation.
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
IN MY SYSTEM THERE IS ONLY OVER CURRENT EARTH FAULT RELAY IS AVAILABLE. FOR THE UNBALANCE SENSING IS THERE ANY RELAY IS AVAILABLE? THE SAME CTs WHICH ARE USED FOR THE OVER CURRENT EARTH FAULT RELAY CAN USE FOR UNBALANCE ALSO?
What are factors to be considered while we selecting the Core Balance Current Transformer for Earth fault protection
when the time of backcharging the transformer three phases only enough or three phase with neutral is must.from these which one is the best one.
What are the classifications of oscillators?
