what is the difference between earthed and unearthed cable?
- 24 Answers
- 51068 Views
- Cords Cable, Essar, Torrent Power, I also Faced
- E-Mail Answers
Answer Posted / rakhi kawatra
Earthed System : the neutal point or mid point connection
is earthed in such manner that even under fault conditions
he max. voltage that can occur between any conductor and
earth does not exceed80% of the nominal system voltage
Unearthed System : an electrical system which does not
fulfil the requirement of the earthed system.
| Is This Answer Correct ? | 10 Yes | 7 No |
Post New Answer View All Answers
Make a list observation on Transformer?
If you have an earth with pilecap then your resistance is really low. why and how?
how to calculate the capacitor to maintain power factor?
What is 11 N1 and 12 N2 in single phase Transformer ?
nwhat are the main Components of servo motor?
what will happen if OLR CT in all phases are short circuted
WHY EARTHING NOT NEEDED IN BATTERY IN SUBSTATION
The specific heats of the gas at constant pressure and constant volume are respectively 1.0 kJ/kg K and 0.72 kJ/kg K; the value of R for the gas is
What happen if 200 KVAR capacitor connected to power continuesly?
what is the control circuit for operating the clean room air shower
2 v/500amp/hr to 1.80vpc at 20 degree celsious 2v/5ooamp/hr to 1.75 vpc at 77degree farren .this is the capacity of a battery .what is the meaning of this . can i get a detailed explenation
Shall I use 40A semiconductor Fuses in 32 A SFU ? Frame size is same. What Happen if Fuses burn on SFU?
Which level of the Transformer oil got dielectric strengh? And why?
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
why do we not use equivalent voltage source in negative sequence equivalent ckt.
