Interested to Buy Any Domain ? << Click Here >> for more details...
defination of plc? why we use plc? application of plc?
advantage of plc?
- 4 Answers
- 21200 Views
- I also Faced
- E-Mail Answers
Answer Posted / siddhesh
plc is a combination of solid state devices 2 perform
specific task using ladder logic
plcs are used to control certain process like power plant
or cement plant
its more reliable than pc,cost efficent initial
installation cost is more,more precise results are
obtained,small size
| Is This Answer Correct ? | 20 Yes | 8 No |
Post New Answer View All Answers
What is intrinsically safe system?
What is the use of double seated valve?
How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?
What are the uses of orifice plates?
for oil & gas industries which zone is normally preferred? why? give its example?
How to find out the current of two motors having same power consumption but different RPM?
How would you choose differential range?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
What pressure results for a flow transmitter of range 0- 180t/h in the dcs and 0-301mbar in the field using square root extraction. Kindly also suggest formulae for the percentages 0,25,50,75,100?
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
hi sir yhis is zahid ali i am preparing for the jspl at oct.4.please send me the recently updated sample paper.
in mass flow meter what is drive friquancy ?
What is the exact differences between HART,FOUNDATION FIELDBUS,PROFIBUS?
what is intrinscily safe system and where we use?
