Answer Posted / prashant

The basic equation is

P = 1.732VIcosA, where CosA can be taken as 0.85
V = 415 V
P = load
From this u have to find the current I and then using the
table select a suitable cable and cable size which can
withstant the current.

What is the diff. between single compression and double compression gland

1997

---

Best way to measure the Soil resistance of rocky soil, three probe method and four probe method

1937

---

What is Control & Relay Panel? And Remote Control Center?

2222

---

what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem

1672

---

What is difference between Over Current & Earth Fault protection?

2446

---

what are the basic insulation levels & what its Unit

2019

---

Difference between shunt, PMG and AREP excitation. Which is the most reliable between PMG and AREP.

9584

---

What is difference between safe PLC and normal PLC

1607

---

What is the direction of current flow in ct secondary...means if the current is flowing from P1 to P2 then what will be the direction of current flow in ct secondaryw

1888

---

Please clarify 1. Icw: rated short circuit working withstand capacity 2. Icu: Rated ultimate breaking capacity 3. Ics: Rated service short circut withstand capacity 4. other specification of ACB

2736

---

1.ZEBRA conductor(large size) 2.KUNDHA conductor( small size ) 3.panther conductor(very small ) 4.lepard conductor (very very small)

2914

---

EXPLAIN USE OF ROCKING ARRANGEMENT IN ELECTRIC HEATING?

1926

---

What is the height of DA, DAL, DB, DC & DDE tower?

2342

---

If an electrical component has a positive temperature coefficient, how come such components have high power losses due to heat if current decreases when resistance increases? assuming power given by I^2*R whereby the Resistance is infinite.

1079

---

WHY THREE PHESE SYSTEM VOLTAGE APPLIED IN 440 VOLT

2345

---