Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / neelam
Electrical Machines are classified in to DC Machines and AC
Machines
DC Machines again Classified in to DC Motor and DC generator
DC motors are broadly classified in to SHUNT and SERIES
Motors and COMPOUND motors
DC Generator is Classified in to SERIES and SHUNT generators
and COMPOUND generators
AC Machines are classified in to SYNCHRONOUS and
ASYNCHRONOUS Machines
Asychronous machines are INDUCTION Machines
| Is This Answer Correct ? | 65 Yes | 2 No |
Post New Answer View All Answers
How CFL &T5 tube light glows?
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
can we synchronize star system generators with delta system transmission line ? and how ?
What is effect of over voltage and under voltage on ACB
how we arrange the hv side with delta connection in case 33/11kv of transformer.
what is kvarh? Please define it With calculation General motors ?
can we conduct the swineburne's test on a dc series motor? why?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
how you taken aotitude test
What is the minimum distance to be maintained in between HT panel and LT panel and Instrument panel as per IEC and NEC standards?
what is laser diodes?
In Power cable specification what is U0/U and Um.
when qty of cable being purchased is not sufficient according to the standard,what should the inspector do to ensure its quality according to the standard?
Trafo ratio is 11kV/6.6kv,Vector group is YND11. What will be the effect if secondary is used for earthed system.
What is meant by reactance voltage?
