tell me about the instrumentation,what is the actual need
of it ?what are the characteristics of a IC engineer ?
- 11 Answers
- 13405 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / raj
instrumentation is the measurement and control of any
physical parameter that changes w.r.t time.Its need is to
control any time varying quantities in the industies.The
characteristics of the inst.engg is to predict the changes
in the parameters and control accordingly.
| Is This Answer Correct ? | 29 Yes | 2 No |
Post New Answer View All Answers
If P will increase then what will happen with PID?
how u choose thermowell lenght n pnumatic C/v size?
can any one explain in which term we are flow flow is it volumetric r is it mass? and y
I faced several time siemens ps2 positioner automatically getting Chang in it's set point direction after auto calibration So is there any causes biside this or any permissives ?
How to Calibrate Level Switch in field
what is isloted barrier how it works and what are the main purpose.how it make safe area.
I m appointed as an automation trainee engineer in small firm in that I am only the one , my company give me a project on s7-200 as i m beginner I don't know how to program so please send me the helpful site so that I complete my project before deadline....please help me out in this critical situation.
What is defferent betwen ESP &PCP PUMP .HOW IT IS WORK?
why orfice is not used for main steam flow calculation
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
Calibration of controller (pneumatic)
where are following valves are applicable to install. can any valve be installed any line. globe valve butterfly valve boll valve gate valve
what is stroke check for field instument transmetter's & AOV's
How many ohms are required for proper earthing?
what is the process to make control schematic ?
