Answer Posted / bikash chandra pal

Abobe two reply explained correctly "what is vector group".
The answer to the last question "why it is needed" is as
follows:-
By virtue of constrction & terminal connections of the
transformer, a difference between primary vector &
secondery vector occurs. We need to know the same for the
following reasons:-

1)Matching of vector group is required (to avoid
circulating current/ fault ), when 2 transformer need to be
operate parallal on a common bus/system.

2) to provide transformer differential protection correctly.

etc

In hydel power plants, L.A's, S.C's are placed inside the control panel boards. what is the purpose? [already the total body was earthed to ground.]

2026

---

1.what is meaning of curve into a mcb. 2.what is basic reason changing of curve

2053

---

what is ATS & RING MAIN UNIT in Distribution System?And its Function.

2058

---

What are all present producing cost of Per KWH of various Fuel?

2644

---

How would you calculate power loss in a resistor?

1128

---

sourse is 66 KV / 350 MVA, transfarmer is 1000 KVA 6.6 / 0.415 kv, iF fault is 28.75 MVA on 0.415 KV Bus then calculat the Transfarmer Impidance

2148

---

what could be the RMS value and average value of a 4 phase sine wave?

1921

---

.php|

2235

---

how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?

2313

---

what's producer of XLPE cable laying in undergroung

2187

---

Give some differences between open loop and closed loop?

1166

---

How to calculate ant test the burden of Current transformer

2499

---

how many synchronous motor are there in any power plant

2053

---

what size steel armoured cable is required to support 1500kva capacity. would 70mm squared be enough or would I need 90 or 120mm squared 3c plus earth

1431

---

Either It Possible a dc Motor to Run On Ac Drive [ Ex : ACS 800 , Yaskawa F7 ] If it is Possible How Pls Inform Me dinesh_elect_eng@yahoo.com

2044

---