why electric shock due to dc is dangerous than that of ac
- 44 Answers
- 60659 Views
- I also Faced
- E-Mail Answers
Answer Posted / praveen v
If going by your analogy Srikanthreddy - 50 Hz being less
than 1000 Hz is more dangerous, then 0 hz being even lesser
than 1000 Hz must be more dangerous.
It is not simply frequency or holding current that matters.
The voltage matters as well.
It all depends on the situations & voltages. Removing all
that, if simply going by the fact that DC causes muscular
contractions & holds you continuously whereas AC holds for a
few moments & then throws you - DC should be considered more
dangerous, even though it is not a wholesome answer.
They are both dangerous.
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
11 kV line deraction check by an Engineer.
i need of the bhel question papers along with answers and also give some website names for the downloading question (electrical and electronics engg question)please help me....
advantages and disadvantages of inverse definite minimum time RELAY
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
What is Surge Capacitor? Why it is use in Generator Circuit Breaker?
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
TELL ME WHAT IS INDUCTOR AND CAPACITOR WHAT IS IT BASIC OPERATION ANDFUNCTION?
why do we put a transformer on soak before loading it
Please explain me about Relay curves and their sources to read ?
What is BusBar integrity test and how it is conducted?
how to find Harmonics and types as per the equipemnts
How work of capacitor in dc supply...???
how could we calculate the no of outgoings from a 800 watt distribution board
How does a television work?
IN 1000kva transformer where the oil and winding temperature sensors is connected
