WHAT IS THE DIFFERENCE BETWEEN PLC AND DCS
Answer Posted / jain
PLC is controlling only one process unit with one CPU.
DCS can control many process units with many CPU.
Is This Answer Correct ? | 25 Yes | 20 No |
Post New Answer View All Answers
where i can get training in INTOOLS and PDMS in Delhi-NCR OR north part of India. please reply with ur ans. at arunsamkaria@ymail.com
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
What is the use of each wire in three wire RTD
plz you help about Que paper of mahagenco previous your,any model paper relad to it{maharastra power genration}
What are different type of instrument cable
what is interface level measurement.who can calibrate interface level measurement transmitter online
Displace type LT to be calibrated in workshop, wt. 40, dia- 60 mm, density- 0.8kg/cm3.
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
How to decrease opening & closing time of on/off valve?
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
why fuse block is not used for AI signal?
In apron feeder how TPH is calculated?
Explain the working of an enraf level gauge.
How does a single acting, spring return ball valve actually work? Does it require continuous air supply?
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?