Technician A says that a fuel tank sending unit will have a
high resistance only when the tank is full. Technician B
says that its resistance when the tank is full depends on
whether the sending unit is designed for use with a
bimetallic gauge or with a magnetic gauge. Who is correct?
- 3 Answers
- 7593 Views
- I also Faced
- E-Mail Answers
Answer Posted / d k sathish kumar
The Technician B is correct,because the resistance is not
constant in both the gauges.....
Its from my practical calculation... but i am not sure...
those who any body knows this ans mail me at below id...
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
How to convert milliampares into flow??
the 3 most common transmitter protocol being in refinery or qatar gas and aramco.
how is work pressure switch& level switch?what is the principle of this?
hiii.... can any one provide me previous years question paper of hindustan petroleum for instrumentation engineering???
components of control circuit belongs to control valve
Why trim span ? How?
Hi my friends Is any one who can assist me in knowing the typical interview questions for system engineer at General Electric pty Ltd
what is span value and zero ? and how set ?
what is the procedure for auto tune in masoneialn 12300 series displacer type transmitter?
What is mean by analytical instrumentation?
I have got a call of IOCL interview for projects having 2yrs experience. What sort of questions should I expect in the interview?
what is interface level measurement.who can calibrate interface level measurement transmitter online
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
How INtools is useful for routine Instrument maintenance?
What is critcal speed. what is resonant frequency. why we want to cross crtcal speed on higher RPM (early).
