Why electrical engineer use Cu Strip for transformer
neutral why not GI Strip? What if we use GI instead of Cu
does it affects the transformer performance.
- 7 Answers
- 15629 Views
- I also Faced
- E-Mail Answers
Answer Posted / rk
GI strip can be used insted of cu but it must be capable of
conduting the current without overheating. now GI strips
are pleantly used everywhere as per cost consideratuon.
| Is This Answer Correct ? | 4 Yes | 4 No |
Post New Answer View All Answers
How to calculate MCB Breaking capacity.
explain the process of commutation in a dc machine. Explain what are inter-poles and why they are required in a dc machine.
we have a lot of model of rectifier but thyristor rectifier is the most rectifier that use in power system. Do you know why this rectifier is used?
How can I calculate per unit (KWH) fuel (Gas/ Diesel both) consumption 1MW unit?
Please help me regarding my one concern. - During earth pit testing we noticed that the Clean earth pit and dirty earth pit showing continuity (Resistance value - 5ohm) . I want to know that if both earth pit have separate location and there is not internal looping between PIT then why such continuity is showing on it . Because of this issue the field side all earthing point showing short. In PLC panel we are providing two types of earthing cable which is coming from separate earth pit (Clean and Dirty earth pit) because of earth PIT showing short our PLC is not complying spec . please help regarding this issues.
What is the percentage loss for aluminium wire for HT line more than 11KVa
What are dcs and plc?
what is the safety of voltage power transformer(2250KVA0
can anybody send the rrb chennai &rrb bopal question papers of 2006&2007.My exam is on 12 oct 2008.Its urgent
What is the disadvantage in proportional controller?
I am abt to give IOCL intrv.Plz sir guide me for IOCL intrvw (Electrical).Which subject to be consider. questions are generally asked from which subject.Plz help me out.
What is a differential amplifier? Also, explain cmrr.
advantages and disadvantages of inverse definite minimum time RELAY
what are the standard IR values should be of R-E, Y-E, B-E, R-Y, Y-B, B-R of VCB in closed condition and in open condition for 500KVA & 1000KVA transformers. and what is the acceptable range when tested by 5000V megger.
how define the torque in ac drive. from electrical side in the drive friquency ,voltage and current three factor is there.
