What is the difference between short circuit and overload
currents?
- 14 Answers
- 58493 Views
- IIIT, I also Faced
- E-Mail Answers
Answer Posted / murali krishna m
Short circuit means there is no resistance, so it will
produce high curent.
Overload means the device draw excess of currrent from the
supply source. due to this the source will be burn or
dameged.
| Is This Answer Correct ? | 56 Yes | 17 No |
Post New Answer View All Answers
What do you mean by a phase angel of instrument transformer?
What types of high speed CMOS circuits have you designed?
A TRANSFORMER 440/400V,DELTA/STAR CONNECTED.THE NEUTRAL CONNECTED WITH GROUND CABLE THAT IS DIRECTLY CONNECTED TO THE PANEL,FROM PANEL IT IS CONNECTED EARTH PIT.IS IT RIGHT? IF IT IS RIGHT LEAKAGE CURRENT AFFECTED.SECONDATY IS PROTECTED WITH EARTH LEAKAGE RELAY.
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
Why you want to join non technical field when you are an engineer?
hello friends..... any one have papers or any study materials?sail ,hpcl...?
Explain the purpose of inductor in an electric circuit?
a starter used for squirrel cage induction motor?
PLZ EXPLAIN CORONA,SKIN,BIRD PALE,SPAN,SAG Effects of power cable.
What are the different types of LT Cables?
Describe the test procedure to determine the vector group
how many parameters can integrate with fire alarm basically ?
does a DG set has low fault level as compared to that of a transformer.If yes then why.
What is the effect on Power factor and capacitor when your company load is more than 70 % of welding transformer
how we calculate torque ? how we improve it ?where torque will either motor or generator ?
