for 1000kva transformer how kvar rating is need for this
PFI plant. and how does it will calculate? and Apmpere
rating of main cable connection?
- 6 Answers
- 16383 Views
- Engineers India, GCC, KP, QPSL, Siemens, I also Faced
- E-Mail Answers
Answer Posted / abdulsubur
hello
It canbe calculate by using this realtion kva=kw\kvar
| Is This Answer Correct ? | 7 Yes | 16 No |
Post New Answer View All Answers
In the formula : Knee point voltage = Burden X alf / class, Please inform what is alf? regards Shashidhar M.R.
What is warm / cold start of HT motors. How many warm start & cold start are possible in a day?
What are the reasons for the parallel operation of transformers?
What is the effect on in Zone and out zone fault if Phase side CT is Vk/2<30 mA and Neutral side is CT is Vk/4<30 mA for Transformer REF protection
What are the advantages of skewing of cage rotor conductors?
How Calculet The UPS AH In Load
how to minimize earth resistance upto 2Ω, if the resistance is 6 Ω ?
Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
what is the difference between 2 way and 4 pole selector switch???
Thermal withstand capability under full short circuit conditions, in terms of number of times of occurrence of short circuit and corresponding anticipated percentage reduction in transformer life.
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
How to Calculate The sag of OPGW in Transmission Line???
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
current transformer balance the power level on both sides. e.g in case of step up, at secondary side voltage rise but current decrease and vice versa in case of step down transformer. but how this power level remains same in case of current transformer and voltage transformer
