Interested to Buy Any Domain ? << Click Here >> for more details...
hi vishok this is noor plz tell me what type problems will
occured i use T/C in the place of RTD in (FEED WATER
TANK),plz send ur e-mail address to my ID
(mail2noor.hyd@gmail.com)
- 6 Answers
- 8165 Views
- I also Faced
- E-Mail Answers
Answer Posted / g.ramki
hi noore use RTD for good in low temp application,feed wtr
tk temp max 100deg.rtd will give good accuracy if u want to
change u ave to lay tc cable.
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
Draw a wheatstone bridge circuit showing supply, meter and 3 wire RTD connection
Working principle of magnetic flow meter ......and calibration procedure of e+h magnetic flowmeter...
How to Calibrate Vortex Flow transmitter in field
How u measure the massflow in orifice flow measurement techniques
what is basic difference between motion balance and force balance in pneumatic instrument?
how to relay switch sense the fault?
What are the interlocks we have to check during the start up of LP/HP compressor?
Sir, I am working as a Instrument Engineer in Grasim Industries. Can any body provide question answer for interview purpose
Identification of control valve parts.
1.what is the effect of vapour presuure in orifice plate flow measurement 2.which is more effective 2 pressure sensors or one single differential pressure sensor in orifice plate measurement 3.how to design a v/i converter and i/v converter 4.how many type of thermocouple are there 5.how many leads are there in thermocouple measurement 6.how pressure sensors are connected in level measurement in differential pressure method 7.what is the output of capacitive pressure sensor (ac or dc),how its o/p is signal charactarized 8.what is the physical meaning of discharge coeeficient,why it is calculated,orifice plate what is its value,why it is less than 1,Q at upstream is equal to or not equal to Q at downstream of orifice plate why?what is vena contracta in orifice plate 9.why rotameter is called variable area flowmeter,it can measure flow even if area is not varying,why it is made tapered 10.design a 10 bit counter ,which counter you will prefer 11.how to remove self heating error in RTD 12.which is more sensitive pt100 or pt50 13.why thermocouple are connected in parallel 14.what is lead contact error in RTD,how to avoid 15.what is P,PI,PID,PD controller,why there is no ID controller 16.what is override,split range,sequential,ratio,feedforward,cascade controller 17.why we moved from SR to JK and then JK to master slave JK flipflop,give correct reason 18.how to measure level of a closed container which contains vapour and liquid,remember no vapour gas should be leaked,so ultrasonic and capacitive is not an option,design another method 19.how to design horse race counter including sensors and signal conditioning element 20.what is bevelling
which type of zones used for boiler? & why ?
what is the difference between attemperator and desuperheater ?
selection of the zener barrier for the hazardeous area zone 0
Instrumentation Safe Guarding test. How to determine the interval time of the test. eg:Halfyearly,Every year,Every three years etc.
