How to connect frequency meter in metering circuit?(single
phase and three phase frequency meter)phase to phase or
phase to neutral
- 7 Answers
- 34197 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / abdul nazir
Same as volt meter connection.
connected parallel with Phase & neutral.
| Is This Answer Correct ? | 38 Yes | 3 No |
Post New Answer View All Answers
What will happen if we introduce negative feedback to a control system that uses a positive feedback?
What is the function of RCBO? What are the different sensitivity ratings & each application?
How to calculate the efficiency of Turbo Generator(Alternator) in general....?
what is the calculation formula for motor starting torque,running torque, running torque.
What is the application of Dyn1 and Dyn11 vector group of transformer?
what do u understand from filter factor of reactor?
If I have 3 essential main switch board and 3 incoming electricity ,but only 1 genset running is that possible.
What are the advantages of vscf wind electrical system?
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
I want to know all basics of electrical engineering
in dc suppy frequency is zero why? if dc frequency is zero how to exist dc transients and ac transients
hi friend i am going too attend for hpcl in this month please help me by sending written test question papers i am in the stream of E.E.E
The 3 phase 400 hp 440 volt slip ring induction motor do not take one phase amps why ? The motor is running good condition
What tests should i carry over on a newly rewinded DC Generator with voltage rating of 38 volts and current rating of 350 amps, to certify that the machine is OK?
if we have 320KVA Genset kindly advice how much load we can put it.
