why most of the substations are rated in multiples of 11?
- 4 Answers
- 7690 Views
- I also Faced
- E-Mail Answers
Answer Posted / niraj shukla
beacause formfactor is = 1.1
| Is This Answer Correct ? | 9 Yes | 3 No |
Post New Answer View All Answers
Could Please Explain briefly. Why used stabilizing resistance series with High impedance bus differential protection relay.
what will happen if multimeter(selector switch at DC voltage) and terminal at current is connected to DC supply?
Which are resistive loads & which one are inductive loads : Refrigerator, Split air conditioner, ceiling fans, well pump, fluoresecent bulbs, T.V, CRT Monitors, Adsl Routers, C.P.U, Printers, Deep Freezers, Speakers, DVD Players, Microwave oven etc. ? Output Power for these Appliances Would be same like this : P = V * A * P.F Or would be changed ? thanks
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
what is meant by tranformer impedance?
can any one tell me about the Extra low voltage systems?From where we give supply to these type of systems??
if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.
How you calculating the 30 Hp 3 phase AC motor of power what size of cable is used for this motor?
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
please I wont know how to calculate the vector group for power transformer ZNyn11 best regard.
WHY NUTRAL GROUND SYSTEM USED IN 33KV SYSTEM
why ahould you show client/engineer activities clearly on the project plan
The principle of switching circuits for different types of batteries in application of storage systems
can anybody send me syllabus of rrb section engg (electrical). and also send previous question pepar...
how oil in the MOCB was reduced compared with OCB? what are the features of the MOCB?
