As a chemical engineer, which are the subjects to whom more
importance should be given....for technical interview.
- 4 Answers
- 8613 Views
- I also Faced
- E-Mail Answers
Answer Posted / engineer
make ur basics very strong....
give special attention to ff,mt,ht and pdc..
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What types of valves are recommended for slurry services?
design calculations for reactor
Under what circumstances are vortex flowmeters the most accurate?
MY generator water cooler inlet line height - 11 mtr inlet water line height - 7 mtr water come into the line from overhead tank, O/H tank height - 20 mtr the first tapping in the inlet line is 2" line which down to 4 mtr level plateform., second tapping in inlet water line goes to a pump 6" line installed at 4 mtr level plateform, pump capacity 200m3/hr, head- 30 mtr, hp-40. the outlet of pump of 6" water line connected to a header of 6 mtr long of 6" line, on this header the six tapping are connected, 4 nos. 3" line goes to 11 mtr height water cooler the pressure of the line is 0.15 to 0.25 kg/cm2, 2" and 4" pipe line connected to a cooler at 4 mtrlevel plateform. my question is, at 11 mtr height level the quantity of water and flow is not sufficient for my cooler, the temp. of cooler is rises much more. you are requested to suggest the modification of pipe line/ pump for take more water flow and pressure (desired pressure is 1 kg/cm2)
What is screen analysis?
wha is Adsorption column chromatography?
Can condensate control in a reboiler cause water hammer problems?
What is condensate lift?
Can any one send me the sample test papers of IOCL entry exam to be held on 6th july 2008. Also plz send the interview questions that cud probably be asked........i wud be highly obliged if u can send a few test paers and other stuff @ inderjeetd@gmail.com.........Inderpreet
Name some common causes of control valve noise?
What is the symbol of sodium?
sir,please give me some exam paper for referance. Thanks & Regards,
Why should a magnesium ribbon be cleaned before burning in air?
How do you design a vapor-liquid separator or a flash drum?
Explain the method adopted to minimize shell side pressure drop in a shell?
