why most of the substations are rated in multiples of 11?
- 4 Answers
- 7689 Views
- I also Faced
- E-Mail Answers
Answer Posted / abduljameel
it is not multiples of 11.It is multiple of 1.11.This is
because of form factor for a sinusoidal curve is 1.11.
| Is This Answer Correct ? | 22 Yes | 1 No |
Post New Answer View All Answers
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
When distance between two pulleys is not fixed, the tension of belt is adjusted by a) driver shaft b) driven shaft c) adjustment screw d) belt
Haw to check conductivity of budbar
hi friends ,iam working as genset AVR service engineer in electrical field from past 2 yrs throughout india . i plan to shift in some other job without travelling in same field because i con't travel,i dont know what i do for that so please guide me what job is suited for me,how i can serch the job please anybody helpme iam totally confused
what is a power factor?
If I have 3 essential main switch board and 3 incoming electricity ,but only 1 genset running is that possible.
Sir, plz tell me how droop setting is done in parellel operation od DG set ? please give practical example ?
defult setting in p220 micom motor proction relay for 11kv,640kw,f.l.a.-40a,1440rpm ht motor?
what is high and low cut off voltage of BB and DG at SPS????????
iam using DM 3251 voltmeter(1 percent accuracy)for 11KV system PT ratio is 11KV/110V.can anybody explain what is the max and min voltage deviation.
Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
why do we need to use 3c+3e cable, normally i select only 3c+e cable and i think it is enough. pls explain the usefull of 3e cable ( in this project the earthing system is well done)
How isolater function when installed inelectrical 440V wiring
When calculating the speed of a rotor required for a particular frequency of synchronous generator we use the equation 60f/p Is this p is the number of pole pairs of rotor & do we consider the number of pole pairs in the stator is 1?
In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.
