Interested to Buy Any Domain ? << Click Here >> for more details...
why we use to transmit the power in three phases intead of
single phase ?
- 4 Answers
- 7036 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
The power generation in india is 11kV 3phase,50Hz & vch is
economical (as per standard)
After genration v have different voltage levels for
consumers(Transmission to Distribution).
in distribution the voltage is steepped down to 440v
because different loads r there for domestic and industrial
needs.
so v can take tappings for any phase for consumers..
| Is This Answer Correct ? | 3 Yes | 6 No |
Post New Answer View All Answers
i need of the bhel question papers along with answers and also give some website names for the downloading question (electrical and electronics engg question)please help me....
how to calculate the no load current in transformer?
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
we have 2.2kw,Y,3000rpm motor but 6leads found in TB what happen if we connect in delta?
What is the differance between 2 dc motors of armature voltage 660 v and 440 v?
Application Comparison between 22KV (UE)and 33KV (E) system. Are we allowed to use 33KV (E) cable in lieu of 22KV (UE) cable. What are the technical disadvantages.
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
what is the differance between HT motors And LT MOTORS.
Is there any relevant technique to produce power from light and heat energy of the sun simultaneosly from same rays of light?
Can double compression glands be used with regular cables?
How delta connection in the primary of distribution transformer reduces harmonics?how delta connections reduces harmonics?Please answer me...Hope that question is correct.
Define steady state error.
WHAT ARE THE EFFECTS OF SERIES RESONANCE AND PARALLEL RESONANCE ON THE CIRCUITS PARAMETERS?
what is the effect of higher value of GD???
what do you mean by type zero control sytem ?Give an practical example of type zero contol sytem?
