Interested to Buy Any Domain ? << Click Here >> for more details...
What is In (current rating) shown on the MCCB? Is this full
load which can withstand by the circuit breaker
- 4 Answers
- 11592 Views
- I also Faced
- E-Mail Answers
Answer Posted / chandra_edu
The current shown in mccb is like below
240/415v
9kA
20A
here 9ka means rated short circuit current when appears
during fault which mccb can withstand
and
20a is actual load current it can withsatnd
| Is This Answer Correct ? | 15 Yes | 4 No |
Post New Answer View All Answers
What are the applications of the electric motors?
anyone please send transformer parameter design formulas & details of tap changer ? plz i have interview this week its more helpful for me ?
what is tri state logic gate
write a program that prints prime numbers from 1-20 in digonal form
state working of halogen lamp?
If I bring a basic electric meter from the States and hook it up in Costa Rica in a development that has only one transformer for the 50 homes, will it still be accurate regarding the usage of kilowatt hours?
What is Auto Mains Failure Panel & Auto Synchronizing Panel
what is the profesional board for electrical engineer what is thepast and during construction for electrical engineering
What is George phenomena to start the synchronus machine?
orifice sizing how done, checking & selection
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
What is 100% protection of generator? Why 100% is not used but 95% is generally used?
What is effect on in zone and out zone fault if CT chosen for phase side is Vk/2<5mA and Neutral side is Vk/2<15mA on REF protection of Transformer
WHAT IS IEC? & WHAT IS BENEFIT TO PRODUCT FROM IEC?
please explain how to do 'pole drop test' on generator?
