Why we call cable rating in SQ.mm.If it is 240 SQ.mm how
much the diameter possible?is there any calculation ?
- 4 Answers
- 17312 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajesh palande
When we say that cable rating is 240 sq mm the user knows
that the area of the conductor is 240 square mm. Hence user
can determine the amount of current that cable can carry.
Calculate the dimension of circle which has a area of 240
sq mm and you get the answere about dia size.
| Is This Answer Correct ? | 12 Yes | 10 No |
Post New Answer View All Answers
whats the application of voltage regulation? and whats the voltage regulation's device?
What OPGW is better than Microwave or PLCC???
How do you calculate the actual power consumption of an inductive load appliance. Say, a deep freezer of 200watts
What is the distance between body earthing and neutral earthing.?
What is the comparison of PILC and XLPE cable
What is open delta Xformer? It's adavntages & Use?
What are the temperature elements?
what is the difference between 4pole & 6pole DC Motors & give advantage ?
100 MVA 3-phase alternator with earthed neutral has a reactance of 5 ohms per phase. what will be the fault MVA of generator.
What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.
How two nos. 130 kw D.C motor get synchronise using D.C drive.
what is vtg limit of earth and neutral at transformer side?
in 132kv substation CRT means
Why neutral point is consider as zero potential?
What is the lifetime of a Thyristor? Is there a recommended lifetime for thyristors after which they should be replaced?
